Do you have intermittent power problems with your layouts?

Be it dirty track, pesky frogs, or switches, GoPack! provides power to your locomotive even when your layout doesn’t. Designed specifically for Paragon3™ locomotives, just plug GoPack! into the onboard port on the locomotive and enjoy continuous power, no matter what layout you're on. Each GoPack! provides between 2-6 seconds of uninterrupted power.

Controllable for DCC:

When used with a Paragon3 Revision H or above decoder, GoPack! has programmable CVs which allow your locomotive to be programmed on the program track even with GoPack! onboard.

Dimensions:

30mm x 13mm x 9mm

Frequently Asked Questions:

Which models can accept a GoPack?

HO Scale Paragon2 and Paragon3 (Revision E and lower Paragon3 decoder boards) can have the GoPack added via solder points. The solder points for the aforementioned decoders are under HO Scale Technical Update Bulletins on our website and a quick link is here.

HO Scale Paragon3 models (Revision H and above Paragon3 decoder boards) have a socket to accept the wiring from a GoPack, making it a PlugNPlay device with no soldering involved.

There is no GoPack for N Scale models at this time.

How do I know which decoder board revision is in my model?

If your model's box has the Accepts GoPack logo, you have a Revision H board installed.

If your model's box has this logo on it, GoPack! is plug and play.

If you see the small socket directly next to the speaker output socket on the decoder, you have a Revision H board.

If you look at the top of the decoder, you will see HO-300-X—whatever is in the place of "X" is what your board revision is.

Which models are GoPack Ready for Plug and Play Operation?

Models with the Accepts GoPack! logo have the Revision H or above board (which means it has the socket), and we’ve done the work to ensure there is enough space under the shell for it to fit under there.

Will the GoPack! Affect My Ability to Program on the Program Track?

Programming on the mainline is no problem with the GoPack! However, if you'd like to read/write CVs on the program track in Paged Mode and/or Direct Mode, you can either:

Set CV221 to disable the GoPack! and then let the capacitors discharge (Revision H decoders and above only),
For a solder-type installation, wire an On/Off switch in-line, or unplug the wiring from the GoPack! socket while programming.

Can I Send My Model in for You to Add a GoPack for Me?

Yes, we offer a flat rate based on the model type. The rates are as follows: HO steam – $149, HO diesel – $119, N steam – $129, and N diesel – $99. These prices include all parts, labor, and return shipping. You would just need to cover the cost of shipping the model to us.

Can I Use the GoPack on Models That Were Not Manufactured by BLI?

We’ve not tested for this, and would not guarantee any compatibility with other models.

Which BLI Models Cannot Work with the GoPack?

Blueline, PCM, and QSI equipped models are not compatible with the GoPack—only Paragon2 and Paragon3 HO Scale models are supported.

HO Accessories

BLI-1005 2-Pack B (c,h)

1018 Pair of SP Daylight Painted Rubber Diaphragms, HO

6023 Pick-up Assembly for Trackmobile

BLI-1004 2-Pack A (a,b)

Non-Traction-Tire Driver - For BLI HO Steam Locomotives

BLI Smoke Fluid 0.25oz bottle

1682 GoPack! Power Continuity Capacitor Pack with plug